User guide

Provisioning the iMG/RG Creating RG Profiles with Field Descriptions
687
AlliedView NMS Administration Guide
Advanced Trigger Parameters These are attributes for when the user wants more control over the trigger feature:
- Secondary Start Port - The start of the secondary port range for an existing
trigger.
- Secondary End Port - The end of the secondary port range for an existing trigger.
- Allow Multiple Hosts - Controls whether a secondary session can be initiated to/
from same or different remote hosts on the same trigger.
- Session Chaining - Whether TCP dynamic sessions can also become triggering
sessions, which allows multi-level session triggering.
- UDP Session Chaining - Whether both UDP and TCP sessions also become
triggering sessions, , which allows multi-level session triggering.
- Binary Address Replacement - enables/disables binary address replacement on an
existing trigger. You can then set the type of address replacement (TCP, UDP, both
or none)
- Address Translation Type - specifies what type of address replacement is set on a
trigger. Incoming packets are searched in order to find their embedded IP address.
The address is then replaced by the correct inside host IP address, and NAT
translates the packets to the correct destination. You can specify whether you want
to carry out address replacement on TCP packets, on UDP packets, or on both
TCP and UDP packets.
Copy values from profile To create a new profile, the user can select an existing profile, which will fill in the
values from that existing profile. The user can then modify any fields.
Create Activated when a Profile Name has been typed, it creates the profile with the
entered values.
Cancel Closes the window
TABLE 7-11 Create RG Internet Profile Security Tab
Attribute Value