User guide

Provisioning the iMG/RG Creating RG Profiles with Field Descriptions
679
AlliedView NMS Administration Guide
TABLE 7-8 Create RG General Port Profile Form - Port Assignment Tab
Attribute Value
Port Assignments The selection made here controls which fields appear on the Provision New Triple
Play Customer form.
Settings - Port assignments will not be displayed when provisioning a new customer.
The values as set in the profile will be used.
Defaults - Port assignments from the profile will be displayed on the provisioning
screen for review and can be modified when provisioning a new customer.
Note: For either setting, after a customer is provisioned, port assignments can
always be viewed/modified from the Port Management View/Modify
screen.
Service None - No service will be configured on the port.
Internet - A data service (type not determined here) will be configured on the port.
TLS - Transparent LAN Service will be configured on the port.
Video - A video service (type not determined here) will be configured on the port.
Voice - A VoIP phone is connected to the LAN port (configured on Voice VLAN)
This service is not available on the HPNA port.
HPNA - used for the iMG6x6MOD. Refer to 7.6.8.
G-Lan - This is the port available when the 1 Gigabit WAN with RJ-45 LAN card is
used. This allows the customer to provision services on the G-Lan port.
Internet/Video - For Media Room. In this configuration a new service is configured for
a LAN port called “'Internet/Video” to indicate that the port can be used for video or
data traffic. Refer to 7.6.10.1.
Speed Autonegotiate - The line will chose the maximum speed/direction it can support.
Coax - Used for P2P RG59 + RG6 coax (10 Meg Full Duplex) in a star/hubspoke top
with software loop detection.
1G Full
1G Half
100M Full -
100M Half -
10M Full -
10M Half -
Upstream Rate Limit (kbps) Speed in kbps for the maximum upstream rate
Downstream Rate Limit (kbps) Speed in kbps for the maximum downstream rate
Admin. State These are set in the General Profile. As with other parameters in the profile, if the
admin state in the profile differs from that on the iMG, then a profile out of sync alarm
is generated on re-discovery.
For profiles that existed before this enhancement, the admin state for ports that have
a service is set to enabled, and for those ports without a service, the admin state is
set to disabled.