User guide

Provisioning the iMG/RG Creating RG Profiles with Field Descriptions
676
AlliedView NMS Administration Guide
Note: To configure the network as depicted in Figure 7-1, the RG General Profile should represent a specific Access Island (a group
of iMAPs sharing a common set of VLANS and router[s]), so the Profile is defining Level-3 details and the VLAN values
associated with it. Therefore if you had 4 access Island you would have 4 general profiles. This is assuming Virtual Routing is
not in use.
Note: For the RG613, RG656, and the iMG646, only the manager password should be changed. (This is because a password can
only be changed by switching to the user for that password. If the administrator changes the password for the Limited User
(with the switching to the Limited User), the RG cannot switch back to Manager User. As a result, if the password for the
Limited User is changed first, and then the Manager User password is changed within 5 minutes, there will be a time-out and
the Manager User password will not be changed. (Waiting 5 minutes between these actions, or changing the Manager User
first allows both changes to be made.)
Note: Future iMG/RG software will allow full support of multiple user id's and privilege levels.
New Limited User Password Password for the Limited User
New Manager Password Password for the user that the AlliedView NMS uses when it provisions the device.
The userID is part of AlliedView NMS, has super user privileges, and cannot be
changed.
Super User Login The super user that can be created and changed by the administrator.
New Super User Password The password for the Super User.
Split Management A subscriber (rather than an NMS administrator) can configure wireless parameters
on wireless iMG devices. Refer to 7.9.6.
Mgmt. Subnets Controls what IP addresses are allowed to log into the iMG/RG using CLI or the iMG/
RG’s web-based GUI.
If no values are entered, any IP address can access the iMG/RG (using a login ID and
password).
Once at least one value is entered, the AlliedView NMS will add its own entry.
Name - A name to identify the subnet. This cannot being with a digit.
Subnet Address - An IP address. Used with the Mask Field to define a range.
Mask - The mask used with the Subnet Address to define a range.
Start Address - The first address in a range
End Address - The last address in a range.
Copy value from Profile To create a new profile, the user can select an existing profile, which will fill in the
values from that existing profile. The user can then modify any fields.
Create Activated when a Profile Name has been typed, it creates the profile with the entered
values.
Cancel Closes the window
TABLE 7-7 Create RG General Port Profile Form - Mgmt InfoTab (Continued)
Attribute Value