User guide

Provisioning the iMG/RG Creating RG Profiles with Field Descriptions
672
AlliedView NMS Administration Guide
FIGURE 7-12 iMG/RG Inventory View Sorted by Upstream Port
7.4 Creating RG Profiles with Field Descriptions
7.4.1 Overview
7.4.1.1 Pre-requisite Steps
Before Profiles can be created, the administrator has already done the following:
• The DHCP servers and DNS servers have been set up
• Routing has been set up
• The G6 setup and if required with the IP address of BBI and AI's default router IP for voice subnet
• Knowledge of the “back office” management subnets
• Knowledge of the vpn “back office” management subnet
Note: These “back office” subnets are separate subnets that ensure that it is possible to communicate with the RG. These require
separate routes as well. Refer to 7.4.2.
• The service VLANs have been set up on the relevant iMAPs.
• Set of RG Profile names that will be used. For General RG Profiles the following shows the naming convention.
For Access Island 1 (AI01)
• SPSI-AI00-P_1I_1V (Phone, 1 Internet, 1 video)
• SPSI-AI00-P_1I_2V (Phone, 1 Internet, 2 video)
For Access Island 1: