User guide

Configuring Network Services Diagnostic Audit
635
AlliedView NMS Administration Guide
6.21.2 Audit the CES Circuit on the iMG6x6MOD or CES8 Card
A similar audit capability is provided for CES Circuits. These entities can be launched from the following locations:
• Port Table – Audits the CES circuit on each selected port from the Port Table in the Network Inventory (can select
multiple ports from the table)
• iMG/RG Table – Audits the CES circuits on each selected iMG from the iMG/RG Table in the Network Inventory (can
select multiple iMGs from the table)
• Card Table – Audits the CES circuits on each selected card from the Card Table in the Network Inventory (can select
multiple cards from the table)
• Node Table – Audits the CES circuits on each selected device from the Node Table in the Network Inventory (can select
multiple devices from the table)
• Physical Network Map – Audits the CES circuits on each selected device from the Physical Network Map, by right-
clicking on the device icon and going to the Network Service sub-menu (can select multiple devices from the map)
A CES Audit will check for configuration problems at both ends of the circuit, if the peer port is also managed by the NMS.
The following figure shows how an audit can be initiated from the pull-down menu in the iMG/RG table.
FIGURE 6-248 Accessing the Audit CES Circuit Panel for iMG6x6MOD
After selecting the Audit CES Circuits in the pull-down, the Diagnostic Audit panel appears, as shown in the following figure.