User guide

Configuring Network Services NTE8 Dual Circuit Provisioning
617
AlliedView NMS Administration Guide
6.17.7.6 Port Thresholds Tab
This form allows the user to modify the threshold values for the DS1/E1 and PPP statisitcs.When a new value is entered in
the New Value field, the Modify button is enabled. These thresholds are set on the device and when crossed will cause
thresholds crossing traps to be sent to the AlliedView NMS. These are displayed in the Event/Alarm tables.
Note: In most cases, the DS1/E1 values are not modified because they are part of the DS1/E1 port profile; if the user does change
a value, the port is now out of sync with its associated profile, and an “*” will appear next to the Profile name on the DS1/E1
Port tab form (as well as the Port Inventory table). In the dual endpoint configuration, the “*” will appear next to the specific
port where the values were changed from the Profile. To Resync the port, the user must re-apply the profile on the DS1/E1
tab form, which puts the values back to what they are in the Profile.
FIGURE 6-228 Port Thresholds Graph Tab for two Endpoints
6.17.7.7 Port Log Tag
The following figure shows the Port Log tab for the two endpoints. These entries are derived from the Syslog system.