User guide

Configuring Network Services Circuit Emulation Service
580
AlliedView NMS Administration Guide
6.16.6.1 DS1 Port Tab
The following figure shows the form that appears when the user double-clicks on port 16.5.
The port 16.5 is on the left, since that is the row that was selected; if the user selected 12.4, port 12.4 would appear on the
left.
The user can change attributes that are part of the Profile, but after clicking on Modify the user would see the Profile with an
‘*” next to it, meaning the Profile is out-of-sync. (This would also show up in the port inventory table.) The user would need
to re-apply the profile to make the ‘*’ disappear.
Note: The DS1 tab shows only the implicit connection between the endpoints; it is the PSPAN tab that explicitly ties the two
endpoints together, discussed below.
FIGURE 6-189 Viewing Dual CES points - DS1 Port Tab