User guide

Configuring Network Services Circuit Emulation Service
575
AlliedView NMS Administration Guide
6.16.3 Create/Provision CES8 card to Support DS1 Ports (Same Device)
The following steps are followed to create a connection between two ports on different cards in the same device, In Figure
6-182, this would be the A to A connection. (The B to B connection is for a port that is connected to a port that is outside
the managed network.)
Note: The two ports can also be on different devices in the same managed network.
To create the cards (if this hasn’t been done already), go to the Card Management Form, find the Slot (in this case 12) that is
not provisioned, and select Create Card. Select the Profile as AutoProv if you wish the card to use the load that is in the
AutoProv profile, the Admin State as UP (assuming you want the card to go into service), and the Ports Type as DS1. Click
on Create, and the card status will change in the Card Management form to a Card Type of CES8.
At this point you can download any CES8 files if the Profile was set to Manually Provisioned.
To provision the IP interface, select the card and View Details, and in the CES8 Card Details Form, select the Protocols tab.
Fill in the required VLAN, IP Address, and Subnet Mask fields, and the optional fields if needed. Select Modify and the values
are applied.
The following figure shows the card on device 10.52.30.36, slot 12, with the values filled for the Protocols tab.
The same procedure is repeated for the card in slot 16.
FIGURE 6-183 Setting the IP Interface for the CES8 Card