User guide

Configuring Network Services Circuit Emulation Service
574
AlliedView NMS Administration Guide
The CES configuration can be either single or dual port; in a dual port configuration both ends of the CES circuit are
iMAP DS1/E1 ports managed by the NMS, while in a single port configuration, only one DS1/E1 port is configured on an
iMAP device managed by the NMS.
• iMG6x6MOD - With the iMG6x6MOD, a circuit emulation service can also be provided. The DS1/E1 port on the iMG
can connect to either a CES8 card or another iMG6x6MOD.
The first part of this section will focus on the CES8 to CES8 card configurations, and includes connections between CES8
cards on the same iMAP as well as different iMAPs.
The second part of this section will focus on the iMG6x6MOD and highlights an iMG6x6MOD with connections to ports on
the CES8 card, with one port to the public voice switching and the other to a PBX/Channel Bank.
6.16.2 CES8 Configuration - Overview of Steps
The steps for provisioning the CES ports are basically the same regardless of whether single or dual port is being configured:
1. Create the Card (this includes provisioning all ports as DS1 or E1) - Refer to 6.16.3
2. Add the IP interface to the card (this includes the VLAN)
3. Create the port profile - Refer to 6.16.4
4. Provision the port - This will also provision the PSPAN and connect the PSPAN to the port. - Refer to 6.16.5
The following figure shows an example configuration using DS1 ports. (E1 ports are similar.) The detailed steps show how
the forms are used.
FIGURE 6-182 CES8 Card Configuration