User guide

Configuring Network Services SuperLoop Prevention (Superring)
549
AlliedView NMS Administration Guide
FIGURE 6-145 Configure EPS Control Ring Panel
The Network VLAN should be highlighted on the left panel. (If not select the loop Network VLAN), then select “Create
Protection Domain”. This brings up the Create New VLAN Protection Domain Dialog Form, as shown in the following
figure.
FIGURE 6-146 Create New VLAN Protection Domain Dialog (Initial)
Enter the Protection Domain Name = jptDom710 and the EPSR Priority=126. By putting in a non-zero value, the user
intends to use the this EPS Ring in a SuperRing configuration. Finish by selecting OK, and the system will show how the
devices will be configured. Refer to the following figures.