User guide

Configuring Network Services Protection Switching-EPSR
522
AlliedView NMS Administration Guide
FIGURE 6-111 Creating Control Ring (Apply Protection Domain)
The user at this point can change the following attributes of the control ring (refer to Table 6-26).
• Interface #1/Primary (whichever one is chosen as the Primary)
• Is Master
• Is Enabled
• EPSR+ - Enhanced Recovery, this is defaulted to the recommended settings, and is disabled if unavailable on the node
software release.
Note: Refer to the Allied Telesis Software Manuals for detailed information about the EPSR+ feature.
Finally, the user clicks Apply Protection Domain. This configures the devices to support the control ring. The Task Details
window appears and the control ring is configured for each device. (If there is an error, the Task Details window can be used
to determine the error condition.)
Once the Protection Domain is applied, a map of the control ring is created that can be viewed, as shown in subsection
6.13.2.5.
Table 6-26 summarizes the fields for the Configure EPS Control Ring Panel
TABLE 6-26 Fields for the Configuration of the EPS Control Ring Panel
Option Purpose
Network Object List Network VLAN Object that is being used to configure the control ring. The format is:
NVLAN:<name of network vlan>[ID]<MID:Vlan[ID]
The ID is the way to uniquely identify the network VLAN.
Create Protection
Domain
Brings up the Create New Protection VLAN Domain Dialog.