User guide

Configuring Network Services Profile Management
459
AlliedView NMS Administration Guide
FIGURE 6-66 Message if Change Mode to PTM
FIGURE 6-67 VCs/VLAN tab when in PTM Mode
Changes to the View/Modify tabs are done on a per tab basis. As an example, if someone makes changes to the General tab
and then makes changes to the VCs/VLANs tab, pressing the “Modify” button will only pick up the current tabs changes.
Because of this, an administrator can change the Transport to “ATM” (from “PTM”) and then make changes to the VCs/
VLANs table. If they then attempt to save the changes to the VCs/VLANs table by selecting the “Modify” button, the data
would not be valid if sent to the port because it would still be configured as “PTM”. In this situation, a dialog box is opened
to indicate that the changes made to the General tab must be saved prior to saving the changes on the VCs/VLANs tab. Refer
to the following figure.