User guide

Controlling and Provisioning Network Devices Port Management (non-iMAP Devices)
350
AlliedView NMS Administration Guide
FIGURE 5-218 Comtrend Boot Configurator
The fields in this form are as follows:
• Mgmt. VLAN - The VLAN used for sending and receiving configuration information and downloads to the CPE.
• Trap Host - The IP address of the Auto Configuration Server (ACS) - the NMS.
• ACS URL - An ACS URL is required to be configured in CPE for using TR-069 for communication with the ACS server
(NMS). The ACS URL pointing to NMS server should be:
http://<NMS IP address>:9797/cwmp/ACS/
Note: The port number has changed; in SP3 this was 9090.
• Inform Interval - How often (in seconds) the CPE contacts the ACS with identification information. The default is 300
(five minutes).
• ACS User and Password - The User ID and password to access the ACS server. The CPE uses this to communicate with
the ACS.
• CPE User and Password - User ID and password to access the CPE. The NMS uses this to communicate with the CPE.
• Config File Name - The name of the configuration file on the TFTP server that includes the values selected here.
• Save Only - If checked, the settings for the configuration file are saved but are not uploaded to the CPE (there is no
physical connection between the ACS and CPE).
5.7.6.6 Staging - Summary
As explained in 5.7.6.4, there is a staging procedure needed for the Comtrend devices so that they may be provisioned.
Staging can be accomplished using one of the following two methods summarized below:
• Method 1