User guide

Controlling and Provisioning Network Devices Port Management (iMAP Devices)
301
AlliedView NMS Administration Guide
Loop Back Status
The DS1/E1 port is considered operationally DOWN when a loopback is
configured, because no “thru service” can be provided. Therefore, when a
loopback is configured on the interface, an administratively UP interface would
be “UP-DOWN-Loopback”", while an administratively DOWN interface
would be “DOWN-DOWN-Loopback”
Loop Back Type The types of loopback:
- NONE
- INWARD - Not supported for the NTE8
- LINE - The entire signal is looped from external equipment only through the DS1/E1
port.
Loop Back Location
Modify If any values are changed, this button is enabled.
Disable / Enable A toggle to enable (if disabled) or disable (if enabled) the port. If the user is disabling the
port, there is a warning.
Alarms... Goes to the Alarm window for the port.
Clear Entry Fields If any values have been added, they are cleared (including pull-downs).
TABLE 5-48 NTE DS1 Port Management - DS1 Port Tab
Field/Button Description