User guide

Controlling and Provisioning Network Devices Port Management (iMAP Devices)
294
AlliedView NMS Administration Guide
5.6.19.2 PSPAN Tab
The PSPAN tab form shows the attributes for the PSPAN that is associated with the port, and, in a dual endpoint
configuration, the attributes for the peer PSPAN.
Line Build Out: The line build out, either in db (long-haul) or feet (short-haul)
Framing Always Unframed, since that is the only type of CES currently supported.
Direction Whether the DS1 interfaces a customer or the network.
Loop Back: Whether to set the port for loopback, and if so either LINE or INWARD (This is
normally done before putting the port in service.
The DS1/E1 port is considered operationally DOWN when a loopback is
configured, because no “thru service” can be provided. Therefore, when a
loopback is configured on the interface, an administratively UP interface would
be “UP-DOWN-Loopback”, while an administratively DOWN interface would
be DOWN-DOWN-Loopback
Runtime Attribute What the line is currently processing for alarms
Modify If any values are changed, this button is enabled.
Disable / Enable A toggle to enable (if disabled) or disable (if enabled) the port. If the user is disabling the
port, there is a warning.
Alarms... Goes to the Alarm window for the port.
Clear Entry Fields If any values have been added, they are cleared (including pull-downs).
TABLE 5-45 CES DS1 Port Management - DS1 Port Tab
Field/Button Description