User guide

Controlling and Provisioning Network Devices Port Management (iMAP Devices)
282
AlliedView NMS Administration Guide
5.6.17.4 SHDSL Configuration Tab - VCs/VLANs
Note: The ADSL16 and ADSL8S cards allow up to four VCs to be configured per port, while the ADSL24 card allows only one VC
per port. The ADSL24A/B card supports 4 VCs.
Refer to 5.6.16.4.
5.6.17.5 SHDSL Configuration Tab - Video Tab
This screen has the same attributes as for ADSL. Refer to 5.6.29
Actual Connect Rate The data rate that was actually attained.
Actual Receiver Gain Receiver Gain in db.
Actual SNR (STU-C,
STU-R)
The signal-noise ratios that were actually attained.
Actual Attenuation
(STU-C, STU-R)
The attenutation that was actually attained.
Actual Output Power
(STU-C, STU-R)
The power outputs that were actually attained
PSD Mask PSD (Power Spectral Density) is a measure of how power in a signal changes over
frequency, and is expressed in dBms per Hz bandwidth. Values for SHDSL16 are:
Symmetric Region 1 (Annex-A)
Symmetric Region 2 (Annex-B)
Tip Ring Configuration Values are Normal and Reversed
Profile Which profile is being used (AutoProv or none, which uses default values).
Description (Customer
ID)
An ID that can be given to uniquely identify the port. In most cases, the subscriber’s
telephone number is used.
Max. Rate The maximum upstream rate that is provisioned.
Min. Rate The minimum upstream rate that is provisioned.
Target SNR Margin Specifies the target signal-to-noise ratio (in dB) to achieve on an ADSL port.
Line Quality Monitor Specifies the ADSL line type as per ITU G.992. Allowed values are FAST and
INTERLEAVE, although FAST is not allowed if the MODE is GLITE. Refer to the iMAP
User’s Guide, Section 4.
VPI Specifies the value for the ATM virtual path identifier on an ADSL port. Refer to the iMAP
User’s Guide, Section 4.
VCI Specifies the value for the ATM virtual channel identifier on an ADSL port. Refer to the
iMAP User’s Guide, Section 4.
MAC Learn Limit Depending on feature provisioning, the number of MAC addresses that can be learned (or
Off)
Modify Enabled when a value in New Value field has been entered, modifies the attributes
according to the updated values.There is an error message if a value is invalid.
Enable Enabled if the port is in an Administrative State of DOWN, enables the port and so brings
the Administrative State to UP. If possible (for example, the ADSL card must be enabled),
the Operational State will change to UP.
Disable Enabled if the port is in an Administrative State of UP, disables the port and so brings the
Administrative State to DOWN. The Operational State will also change to DOWN.
Alarms Invokes the Alarm table of the Fault Management Object.
TABLE 5-41 SHDSL Configuration Tab - General
Field/Button Description