User guide

Controlling and Provisioning Network Devices Port Management (iMAP Devices)
266
AlliedView NMS Administration Guide
The values on this form can be modified as follows:
Note: This requires that the port be disabled, which will interrupt service on the port.
1. Click Disable to disable the port. A dialog box will appear warning you that service on the port will be interrupted. If you
wish to proceed, click Yes.
2. Modify the information as needed.
3. Click Modify to save the changes.
4. Click Enable to re-enable the port.
For an ADSL Bonded port, the General Tab of the Port Details window contains information about the ATMBond. Each
ADSL port that belong to the bond group has its own tab. There is the button on the panel “Add Bonded Port.”, to allow
adding another port to the group. This button is disabled when the group is full. Refer to the following figures.
Note: Currently only two pairs can be bonded, but a group can be created with only one pair.
Power Mgmt Reentry
Delay
The amount of time that must elapse before re-entering the Low Power state after a
transition to the Full On state. (Should not be set to a value less than 120 seconds)
Power Mgmt Trim The maximum aggregate transmit power reduction (trimming) that can be performed with
each power trim operation in the Low Power state.
Power Mgmt Trim Delay The amount of time that must elapse before an additional reduction (trimming) of power
occurs in the Low Power state.
Low Power Min Rate The minimum net data rate for the bearer channel while operating in the Low Power
state.
The value for LOWPOWERRATE must be between MAXDOWNSTREAMRATE and
MINDOWNSTREAMRATE
Max. Upstream Nominal
PSD
VDSL/ADSL power spectrum density limits are defined by the band plan and determine
this value.
Max. Downstream
Nominal PSD
VDSL/ADSL power spectrum density limits are defined by the band plan and determine
this value.
Modify Enabled when a value in New Value field has been entered, modifies the attributes
according to the updated values.There is an error message if a value is invalid.
Clear Entry Fields Clear any fields that have been datafilled but not yet Modified
Enable Enabled if the port is in an Administrative State of DOWN, enables the port and so brings
the Administrative State to UP. If possible (for example, the ADSL card must be enabled),
the Operational State will change to UP.
Disable Enabled if the port is in an Administrative State of UP, disables the port and so brings the
Administrative State to DOWN. The Operational State will also change to DOWN.
Alarms Invokes the Alarm table of the Fault Management Object.
TABLE 5-36 ADSL Configuration Form, General Tab (Continued)
Field/Button Description