User guide

Controlling and Provisioning Network Devices Port Management (iMAP Devices)
265
AlliedView NMS Administration Guide
Connection State The connection state, such as Idle or Showtime
Actual Line Std. The line standard that was actually chosen.
Actual Databoost Whether the DATABOOST feature has been implemented
Actual Line Type The line type that was actually chosen.
Actual Upstream/
Downstream Rate
The upstream/downstream rate that was actually attained.
Max. Attainable Upstream/
Downstream Rate
The possible upstream/downstream rate according to dsl type and mode.
Actual SNR (Near End/Far
End)
The signal-noise ratio for near end/far end that was actually attained.
Actual Attenuation (Near
End/Far End)
The attenutation for near end/far end that was actually attained.
Actual Output Power
(Near End/Far End)
The output power achieved for near end/far end.
Actual Software Annex The Annex (A, B, or C) that is being used
Actual Power Mgmt State The state the interface is in for power reduction (Full On, Low Power, Idle)
Actual Power Mgmt Status Whether the power management feature has been activated for the interface
Actual Upstream INP The actual impulse noise protection value for upstream
Actual Downstream INP The actual impulse noise protection value for downstream
Profile Which profile is being used (AutoProv or none, which uses default values).
Description (Customer ID) An ID that can be given to uniquely identify the port. In most cases, the subscriber’s
telephone number is used. Refer to 7.2.7.
Max. Upstream Rate The maximum upstream rate that is provisioned.
Min. Upstream Rate The minimum upstream rate that is provisioned.
Max. Downstream Rate The maximum downstream rate that is provisioned.
Min. Downstream Rate The minimum downstream rate that is provisioned.
Target SNR Margin Specifies the target signal-to-noise ratio (in dB) to achieve on an ADSL port.
ADSL Line Type Specifies the ADSL line type as per ITU G.992. Allowed values are FAST and
INTERLEAVE, although FAST is not allowed if the MODE is GLITE. Refer to the iMAP
User’s Guide, Section 4.
ADSL Mode Specifies the ADSL line mode standard. Refer to the iMAP User’s Guide, Section 4.
ADSL Databoost Whether the Databoost feature has been provisioned
Line Quality Monitor The level the line quality monitor has been set at. Refer to the iMAP User Guide.
Max. Interleave Delay Specifies the maximum interleave delay in milliseconds used when the ADSL linetype is set
to INTERLEAVE. Refer to the iMAP User’s Guide, Section 4.
Echo Cancel Specifies whether echo cancellation is utilized on ADSL ports running G.DMT mode as per
ITU-T. Refer to the iMAP User’s Guide, Section 4.
Max. # of Learned MAC
Addresses
Depending on feature provisioning, the number of MAC addresses that can be learned (or
Off)
Minimum Upstream INP Sets the minimum impulse noise protection value for upstream.
Minimum Downstream INP Sets the minimum impulse noise protection value for downstream.
Power Management Changes the current power management state.
TABLE 5-36 ADSL Configuration Form, General Tab (Continued)
Field/Button Description