User guide

Controlling and Provisioning Network Devices Configure VLAN (Chassis View)
200
AlliedView NMS Administration Guide
Note: To see the status of a port, place the cursor over a port in the graphic and a tooltip appears, which shows the permitted
states for that port. Allowed states are Plain, Tagged, Untagged, Linked-Tagged, Unlink-Tagged, Linked, and Translated. (The
actual states available depend on the configuration.) If a port is Plain, the user can then click on the port and cycle the status
from U (untagged) to T (tagged) to X (translated). Clicking on the port again will return the port to blank. When a port is
marked as untagged for a VLAN other than the default VLAN, that port can only be marked as tagged for the other VLANs.
In this case the port alternates only between tagged and blank.
Note: For the EPON2 card, the user can click on the ONUs button and a pop-up will show the VLAN status of the ONU ports. To
close the pop-up, click on the square labeled Port <no.> ONUs, as highlighted in Figure 5-95.
Note: To change the status for a set of ports, select and hold the SHIFT key and then click and drag the left mouse button over
multiple ports.
Caution: The FE/FX10 cards have certain restrictions on VLAN translations, and the user must be aware of these so as not to
compromise service. Refer to 6.9.3.2.
FIGURE 5-96 Entering a translated VLAN (State will go from U to X)
Reset Cancels the changes that were made using the graphic. The graphic reverts to the original port
assignments.
Apply Makes and confirms the port assignment changes. If any errors occur, (such as a conflict with another
user making port changes), there is an error message and the history window is displayed.
Less/More This shows/hides the additional attributes, one for Rapier-specific Vlan parameters, one for iMAP-
specific VLAN parameters, such as specific translations. These are explained above.
Show Links If the VLAN is configured as part of a Network VLAN, selecting this button will show the physical
links over which the logical VLAN links are configured.
View Last
Action
This will open up the Recent Commands... window and show what command and response were
involved in the last action on the form.
Close Closes the form.
If this VLAN Configuration form is invoked from the Chassis View, the Close button is replaced with
the Chassis View button, to return to the first view of the device.
TABLE 5-12 VLAN Configuration Options
Screen Item Description