Installation guide

AT-S62 Version 1.4.0 Software Release Notes
PN: 613-000490 Rev. A 7 Allied Telesyn, Inc.
 MAC addresses. You must move the cursor manually from field to field when entering a static
MAC address in the MAC Address field of the Add MAC Address page of the web browser
interface. The cursor does not move automatically. (1699, 2123)
 AT-A45 module. The activity LED on the AT-A45 module only illuminates for egress traffic.
This does not affect the operation of the module. (1775)
 AT-A46 module. The duplex mode LED on the AT-A46 module may remain on when the mod-
ule is installed but before a cable is connected to the port or after the link to the end node is
lost. This does not affect the operation of the module. (1048)
 TACACS+. The TACACS+ client software on the switch supports Password Protection Proto-
col (PAP), but not Challenge Handshake Authentication Protocol (CHAP) or AppleTalk
Remote Access Protocol (ARAP). (1078)
 Statistics. Tagged frames larger than 1522 bytes are counted in the “Jabber” statistics
counter. This applies to the base ports on the switch and the AT-A45 module port, but not to
other expansion module ports. (1705)
 Port trunks. The following load distribution methods for static and LACP port trunks are non-
functional: source IP address, destination IP address, and source and destination IP
addresses. If you select one of these methods for a trunk, the switch instead uses source
MAC address, destination MAC address, or source and destination MAC addresses, respec-
tively.
 VLANs. The AT-8550GB and AT-8550SP switches can take up to 20 seconds to complete
the VLAN configuration process when the VLAN mode is changed from user-configured
VLANs to one of the multiple VLAN modes, or vice versa. During this period you are not per-
mitted to manage the switch. (2708)
 IGMP. The switch, when configured for IGMP, will not register a tagged IGMP query in the
IGMP routers list if ingress filtering is disabled and the VID in the packet does not match the
VID of the ingress port. (1493)
 SNTP. The SNTP client software on the switch sends a Transmit Time Stamp with a value
NULL when synchronizing with a Network Time Protocol server. This does not affect the
operation of the SNTP client software. (1676)