User`s guide

AT-S60 Version 2.0.0 NE Management Software Release Notes
PN 613-50544-00 Rev B 6 Allied Telesyn, Inc.
AT-8413 Line Card and Auto-Negotiation. When Auto-Negotiation on the twisted pair port
on the AT-8413 line card was enabled or disabled while the port was forwarding traffic at 10 or
100 Mbps may impair port performance, throughput could have dropped to 60%. This issue
has been resolved.
AT-8413 Line Card and Gigabit Performance. The twisted pair port on the AT-8413 line card,
when operating at 1000 Mbps, had a maximum throughput of 1,407,373 packets per second in
half-duplex operation. This issue has been resolved.
AT-8413 Line Card and Half-duplex Mode. The 10/100/1000 Base-T twisted pair port on the
AT-8413 line card experienced a throughput loss if configured to operated at 1000 Mbps at
half-duplex. This issue has been resolved.
DELETE VLAN Command. No error given for partial command. If you entered delete
vlan=name, the ports in the VLAN were not deleted and you did not receive an error message
stating that you entered a partial command. This issue has been resolved.
DELETE VLAN Command. All option is not functional. The "all" option of the DELETE VLAN
command was not completely functional. This issue has been resolved.
RESET MSTP and SET MSTP DEFAULT Commands. The former command returned all MSTP
parameters to the default settings, but did not delete MSTI IDs. The latter command did the
same thing, but it also deleted the MSTI IDs. This issue has been resolved.
SET ASYN Command. The help message for this command listed 56,700 bps as a valid speed
for the RS-232 Terminal Port which is invalid. This issue has been resolved.
SET IP ROUTE Command. This command is nonfunctional. To set the default gateway
address, use the Telnet or web interface. This issue has been resolved.
SET PORT SECURITY Command. If you want to assign limited security mode to a port and you
want to specify how many MAC addresses can be learned on this same port, you must use two
separate commands. This issue has been resolved.
SET SWITCH PORT Command. The PRIORITY option in this command is nonfunctional. To set
a port's priority, use the menu or web interface. This issue has been resolved.
SET SWITCH PORT Command and the AT-8413 Line Card. You could not use the SET
SWITCH PORT command to change the speed of the 10/100/1000 Base-T port on an AT-8413
line card. This issue has been resolved.
SHOW CONFIG Command. Typing "Q" to stop the information displayed by this command
may not have worked the first time. This issue has been resolved.