User`s guide

AT-S25 Management Software User’s Guide

Configuring the

Management

Passwords

There are two levels of management access on an AT-8300 Series stack:

Manager and Operator. When you log in as a Manager, you can view and

configure all of a stack’s operating parameters. When you log in as an

Operator, you can only view the operating parameters; you cannot

change any values.

You log in as a Manager or an Operator by entering the appropriate

password when you start an AT-S25 management software.

❑ The default login password for Manager access is “friend”.

❑ The default password for Operator access is “operator”.

Note

The passwords are case sensitive.

To change the Manager or Operator password, perform the following

procedure:

1. From the Main Menu, type 4 to select Administration Menu.

The Administration Menu as shown in Figure 10 on page 43 is

displayed.

2. From the Administration Menu, type 8 to select Set Passwords. The

Passwords Menu in Figure 11 is displayed.

Figure 11 Passwords Menu

3. Type 1 to change the Manager password, or type 2 to change the

Operator password.

4. When prompted, enter the current Manager or Operator password.

5. When prompted, enter the new Manager or Operator password.