Installation guide

AT-S25 Management Software Release Notes
613-50514-00 Rev A 6 Allied Telesyn, Inc.
Using XModem to Download the AT-S25 Version 2.0.2 Image File
This section contains the procedure for upgrading a switch module running Version 1.5.6.2 or
an earlier version to Version 2.0.2 from a local management interface using the XModem
protocol. (You could also load the new software using TFTP, as explain in the previous section.)
NOTE:
This method is used to upgrade the software to an individual switch module of a
stack or to a stand-alone switch module. If the switch module is a member of a stack,
the stacking cable(s) must be disconnected from the module before starting this
procedure. This method may be performed from a local host PC only.
NOTE:
Hilgraeve HyperTerminal software is used in this XModem procedure.
NOTE:
The ATS25_V1563.IMG file is not required when using the XModem method.
To download the AT-S25 Version 2.0.2 image file “ATS25_V202.IMG” using the XModem
method, perform the following procedure:
1. In HyperTerminal, verify that your current port settings are set as follows:
- Bits per second = “9600”
- Data bits = “8”
- Parity = “None”
- Stop bits = “1”
- Flow control = “None”
2. Start the AT-S25 management software. The System Booting window as shown in Figure 1
is running.
Figure 1 System Booting Window