Installation guide

AT-S25 Management Software Release Notes
613-50514-00 Rev A 14 Allied Telesyn, Inc.
Previous Version 2.0.0
New Features
❑ Support for Rapid Spanning Tree Protocol. For more information on this feature, refer to
the AT-S25 Management Software User’s Guide.
❑ Allows stacking up to eight switches per stack.
❑ Implements a new menu-driven user interfaces for the Console and Telnet, and as well
as a new look and feel web browser management, for easy access to the switch.
❑ Allows two management access levels on each AT-8316F or an AT-8324 Switch:
- Manager Access: When you log in as a Manager, you can view and
configure all of a switch’s operating parameters. The username for
Manager access is “manager” and the default password is “friend”.
- Operator Access: When you log in as an Operator, you can only view the
operating parameters; you cannot change any values. The username for
Operator access is “operator” and the default password is “operator”.
Resolved Issues
❑ AT-S25 Version 2.0.0 supports the following appliqué types: AT-A14, AT-A15,
AT-A17, AT-A17/SM15, AT-A18, and AT-A19.
❑ Port Trunking is now supported on all the modules and ports, including the gigabit
uplink ports with the condition that these appliqués are of the same kind.
❑ AT-S25 Version 2.0.0 supports IGMP Snooping.
❑ In Version 2.0.0, the AT-8316F or AT-8324 switch management allows pinging through
the Master and/or Slave port. The maximum pinging length is 65,500 bytes.
❑ Most the features supported by the Console or Telnet management interfaces are now
supported by Web Browser or SNMP interfaces also.
❑ The problem has been resolved where the VLAN parameters on the untagged ports of a
slave unit in a stack were not retained properly after the stack was power cycled.