Installation guide

AT-S25 Management Software Release Notes

613-50514-00 Rev A 10 Allied Telesyn, Inc.

When the image file is downloaded to all the modules in the stack, make sure to set the

terminal speed back to the default of 9600 by performing the following steps:

1. From the local management interface menu, select Disconnect from the Call menu or click

the Disconnect icon .

2. From the local management interface menu bar, select Properties from the File menu or click

the Properties icon . The AT-S25 Properties window in Figure 3 on page 7 is displayed.

3. Click the Configure button. The Properties window of the connecting COM in Figure 4 on

page 8 is displayed.

4. From the local management interface menu, select Connect from the Call menu or click the

Call icon .

5. Click the Restore Defaults button, the Bits per second field is displayed with 9600 as its

setting; and click OK.

The system is now rebooted and you are returned to the AT-S25 management software