User`s guide

Section II: Local and Telnet Management
46
4. Adjust the parameters as desired. To change a value, type its
corresponding number and, when prompted, enter the new value.
The parameters are described below.
1 - GET Community
2 - SET Community
3- Trap Community
Use these parameters to set a switch’s SNMP community strings.
4 - Trap Receiver 1
5 - Trap Receiver 2
6 - Trap Receiver 3
7 - Trap Receiver 4
Use these selections to specify the IP addresses of up to four
management workstations on your network to receive traps from
the switch.
5. After making your changes, type S to select Save Configuration
Changes.
Changes to the SNMP parameters are immediately activated on
the switch.