Manualshelf

Installation guide

ManualsBrandsAllied Telesis ManualsComputer equipmentAT-8016F/SC
12345678910
AT-S39 Version 3.0.1 Management Software Release Notes
PN 613-50389-00 Rev A 8 Allied Telesyn, Inc.
• New SET SWITCH TRUNK Command
This new command line interface command changes the load distribution method of an
existing port trunk. The format of the command is:
SET SWITCH TRUNK=1 SELECT=MACSRC|MACBOTH
The MACSRC option configures the trunk for Source Address Trunking. The MACBOTH
option configures the trunk for Source Address/Destination Address Trunking. Refer to
the AT-S39 User’s Guide for a description of the load distribution methods.
Resolved Issues
• Creating Tagged VLANs in a Web Browser Management Session
A web browser management session would not allow you to select a port as a tagged
port when creating or modifying a VLAN. This problem has been resolved.
• IGMP Host/Router Timeout
The Host/Router Timeout was nonfunctional. This problem has been resolved.
• GBIC Ports 25 and 26 in the AT-8024GB Switch
The graphical image of an AT-8024GB switch in a web browser management session did
not include the GBIC expansion slots if no GBICs were installed. This problem has been
resolved.
• ACTIVATE STP and ACTIVATE RSTP
The confirmation prompt displayed by these commands did not pause for user input.
This problem has been resolved.
• Up and Down Arrow Keys and the Tab Key
A switch would periodically hang when the up and down arrow keys were used to view
the command history in the command line interface. The Tab key could also cause this
problem. This problem has been resolved.
• Web Browser Interface
The web browser interface would periodically show the second expansion slot in an AT-
8016F or AT-8024M switch as populated when the slot was empty. This problem has
been resolved.
• STP and RSTP Error Messages
Error messages are now displayed if you enter incompatible hello time, forward delay,
and maximum age time values.
• Management Session of a Slave Switch
Ending a management session of a slave switch caused the management session to
hang if configuration changes had not been saved. This problem has been resolved.