Installation guide

AT-S39 Version 3.0.1 Management Software Release Notes
PN 613-50389-00 Rev A 4 Allied Telesyn, Inc.
The following menu is displayed. (The menu may differ depending on the version of
management software on the switch.)
Figure 1 Xmodem Downloads & Uploads Menu
4. Type 1 to select Xmodem Image/Bootloader Download.
The following prompt is displayed:
You are going to invoke the Xmodem download utility.
Do you wish to continue? [Yes/No]
5. Type Y for Yes.
The prompt “Downloading” is displayed.
6. Begin the file transfer of the new management software image. The transfer protocol must
be Xmodem or 1K Xmodem.
Steps 7 through 10 illustrate how to transfer the file using the Hilgraeve HyperTerminal
program.
7. From the HyperTerminal main window, select the Transfer menu. Then select Send File
from the pull-down menu, as shown in Figure 2.
Figure 2 Local Management Window
Allied Telesyn AT-8024 Ethernet Switch
Xmodem Downloads & Uploads
1 - Xmodem Image/Boot Loader Download
2 - Xmodem Config Download
3 - Xmodem Image Upload
4 - Xmodem Config Upload
R -
Return to Previous Menu
Enter your selection: