Installation guide

AT-S39 Version 3.0.1 Management Software Release Notes
PN 613-50389-00 Rev A 18 Allied Telesyn, Inc.
Previous Version 1.3.1
New Features
• Port Status in a Web Browser Management Session
You can display the status of multiple ports simultaneously from a web browser
management session. In previous software versions you could display the status of only
one port at a time.
• Delete MAC Address Menu Selection
The Delete MAC Address menu selection in the MAC Address Table menu of a local or
Telnet management session can now delete both dynamic and static MAC addresses from
the MAC address table. In previous management versions this selection could only delete
static addresses. You cannot use this selection to delete a switch’s MAC address, an STP
BPDU MAC address, or a broadcast address.
Resolved Issues
• Static IP Address
You could not establish a Telnet or web browser management session on a switch or ping
a switch if the BOOTP/DHCP option was disabled after the unit had received a static IP
address. This problem has been resolved.
• New Password Confirmation Message
The management software now displays the message “Saving password” when you
change the management software’s password.
• TFTP GET Commands
The management software would display the following message during a local
management session whenever the switch received a broadcast TFTP GET command
specifying a filename other than ATS39.IMG, ATS39.CFG, or ATS39.LDR: “Upload file name
not matching with predetermined name - upload aborted.” The management software has
been modified to ignore all TFTP messages that are not directed to the switch.
• TFTP PUT Commands
Previously, the management software would not validate a file that was downloaded with
a TFTP PUT command until the switch had received the entire file, leaving open the
possibility of loading an invalid image and corrupting the firmware. This has been resolved
by having the management software check for a valid filename (ATS39.IMG, ATS39.CFG, or
ATS39.LDR) in the TFTP PUT command. Only if the filename is valid will the switch accept
the file.