Installation guide

AT-S39 Version 3.0.1 Management Software Release Notes
PN 613-50389-00 Rev A 15 Allied Telesyn, Inc.
Previous Version 1.4.1
Resolved Issues
• Releasing an IP Address
The switch, when reset or power cycled, would not automatically release an IP address
obtained from a BOOTP or DHCP server. Instead, the address would have to be manually
released using the L - Release DHCP IP Address command in the Administration Menu. This
issue has been resolved. An IP address obtained from a BOOTP or DHCP server is now
released automatically whenever the unit is reset or power cycled. Consequently, the L -
Release DHCP IP Address command has been removed from the Administration Menu.
•STP
The following STP issues were resolved:
- Changes to the STP parameters were not saved and, consequently, were lost when the
switch was reset.
- The STP settings were not applied correctly on a port trunk.
• PVID Values
Not all PVID values were returned to “1” when the switch’s management software was
returned to its default values. This issue has been resolved.
• MDI and MDI-X Configuration
The software would occasionally fail to properly configure a port as MDI or MDI-X when the
setting was specified manually. This issue has been resolved.
• Telnet Management Session
A Telnet management session of a slave switch in an enhanced stack periodically failed.
This issue has been resolved.
• Local Management Session Menus
The management menus were occasionally illegible. This issue has been resolved.
• Port Link Status
The link status of a port was not always reported correctly to an end node when a port was
configured manually. This issue has been resolved.
• VLAN Port Mirror
The management software did not properly configure a port selected to function as a port
mirror of a VLAN. This issue has been resolved.