Installation guide

AT-S39 Version 3.0.1 Management Software Release Notes
PN 613-50389-00 Rev A 14 Allied Telesyn, Inc.
• STP Values
The switch would periodically fail to save STP settings. This issue has been resolved.
• Web Browser Management
A switch would periodically fail if managed from a web browser. This issue has been
resolved.
• IP Parameters from a BOOTP or DHCP Server
The switch would fail to obtain its IP configuration from a BOOTP or DHCP server if STP
was enabled. This issue has been resolved.
• Disabling IGMP Snooping
The MAC addresses of host nodes and multicast routers would change into static
addresses when IGMP snooping was disabled. The addresses would remain in the MAC
address table until IGMP snooping was enabled again. This issue has been resolved.
• Local Management and SNMP Management
Managing a switch through a local management session and with SNMP simultaneously
would cause the local session to fail. This issue has been resolved.
• Returning a Switch to the Default Settings
Not all ports were returned to the Default_VLAN and some parameter settings were not
correctly changed when the switch was returned to its default settings. This issue has
been resolved.
Previous Version 1.4.2
New Features
• Management VLAN
The management software now allows you to specify any tagged or untagged VLAN in
your network as a management VLAN. This feature can greatly simplify the task of
configuring your AT-8000 Series switches for remote management.
• Fan Failure Trap
An SNMP trap for fan failure has been added to the software.
Resolved Issues
• Status of the VLAN Mode
A change in the VLAN mode of a switch was not always reflected in the management
screen. This issue has been resolved.
• SNMP Management
Fixed problems with several MIB objects.