Installation guide

AT-S39 Version 3.0.1 Management Software Release Notes
PN 613-50389-00 Rev A 13 Allied Telesyn, Inc.
• Web Browser Management
Below are new web browser management functions:
- Enhanced stacking
- Resetting a switch
- Pinging a remote system
- Displaying IGMP host nodes and multicast routers
- Adding static multicast addresses
• Command Line Interface
The AT-S39 software now features a command line interface for configuring a switch’s
parameters from a command line prompt. For information on the commands, refer to
the AT-S39 Command Line Interface User’s Guide.
• Load Distribution Method in Port Trunks
You can now choose the load distribution method of a port trunk. The selections are
Source Address (SA) or Source Address / Destination Address (SA/DA).
• Auto-speed Detection on the RS-232 Terminal Port
Auto-speed detection on the console port has been expanded. The switch now adjusts
the speed of the RS232 Terminal Port each time you start a local management session.
You activate the auto-speed feature by pressing the Return key twice when you begin a
local management session.
Resolved Issues
• Saving IP and Password Changes
The switch did not always save IP and password changes. This issue has been resolved.
• Management Sessions with a Slave Switch
Management sessions with slave switches through a master switch would periodically
fail or the menus would be illegible. This issue has been resolved.
• Changing the VLAN Mode
The switch would fail to accept a change of the VLAN mode. This issue has been
resolved.
• Download File Checking
The management software now performs a validation check on a file before accepting
the file for download. This prevents the switch from downloading an invalid file. The
program also performs a CRC error check to prevent the download of a corrupted file.