User`s guide

Configuring Multicast Forwarding
Page 127
Figure 93: Multicast Group Page
The Multicast Group Page contains the following fields:
• Enable Bridge Multicast Filtering — Indicates if bridge Multicast filtering is enabled on the device.
The possible field values are:
– Checked — Enables Multicast filtering on the device.
– Unchecked — Disables Multicast filtering on the device. If Multicast filtering is disabled, Multicast frames
are flooded to all ports in the relevant VLAN. Disabled is the default value.
• VLAN ID — Displays the VLAN for which Multicast parameters are displayed.
• Bridge Multicast Address — Identifies the Multicast group MAC address/IP address.
• Select the interfaces displayed in the table.
– Ports of Unit — Specifies the port and stacking member for which the Multicast group settings are
displayed.
– Trunk — Specifies the trunk for which the Multicast group settings are displayed.
• Interface — Displays the currently defined interface.
• Interface Status — Displays the current interface status.
2. Check the Enable Bridge Multicast Filtering checkbox.
3. Click Add. The Add Multicast Group Page opens: