System information

Operation SET USER 1-93
Software Release 2.0.1
C613-03018-00 REV A
SET USER
Syntax
SET USER=login-name [CALLINGNUMBER=number]
[CBNUMBER=e164number] [DESCRIPTION=description]
[PASSWORD=password] [PRIVILEGE={USER|MANAGER|
SECURITYOFFICER}] [TELNET={YES|NO}] [IPADDRESS=ipadd]
[IPXNETWORK=network] [NETMASK=ipadd] [MTU=40..1500]
SET USER [LOGINFAIL=1..10] [LOCKOUTPD=0..30000]
[MANPWDFAIL=1..5] [SECUREDELAY=10..600]
[MINPWDLEN=1..23] [TACRETRIES=0..10] [TACTIMEOUT=1..60]
where:
■ login-name is a character string, 1 to 64 characters in length. Valid characters
are uppercase letters (A–Z), lowercase letters (a–z), and decimal digits (0–9).
The string may not contain spaces.
■ password is a character string, 1 to 32 characters in length. Valid characters
are any printable character. If the string contains spaces it must be enclosed
in double quotes.
■ number is an ISDN phone number, 1 to 32 characters in length. Valid
characters are any printable characters. If the string contains spaces it must
be enclosed in double quotes.
■
e164number is the phone number to dial when performing callback. It may
contain digits (0–9) and should be a valid phone number as described in
CCITT standard E.164.
■
description is a character string, 1 to 23 characters in length. Valid characters
are any printable character. If the string contains spaces it must be enclosed
in double quotes.
■
ipadd is an IP address in dotted decimal notation.
■
network is a valid Novell network number, expressed as a hexadecimal
number. Leading zeros may be omitted.
Description
This command modifies a user record in the User Authentication Database or
alters global parameters affecting the User Authentication Facility.
The first variant of the command is used to alter a user record in the User
Authentication Database. The USER parameter specifies the login name of a
user in the database. Other parameters specified on the command modify the
information stored in the database for that user. The second variant of the
command is used to alter the global security parameters for the User
Authentication Facility.
The CALLINGNUMBER parameter specifies the calling number to be used to
authenticate incoming calls from L2TP and ISDN services that provide caller
ID information. While any printable characters will be accepted for this
parameter, the calling number it is to match is likely to contain only decimal
digits. Any other characters used in this parameter are unlikely to match the
calling number of an incoming call.
The CBNUMBER parameter specifies the ISDN phone number to use when
making a call back to a remote user using the PPP callback facility.