System information

Operation CREATE CONFIG 1-49
Software Release 2.0.1
C613-03018-00 REV A
For security reasons this command will only be accepted if the user has SECURITY
OFFICER privilege.
Examples
To add the IP addresses 192.168.11.7 and 192.168.202.9 as Remote Security
Officers, use the commands:
ADD USER RSO IP=192.168.11.7
ADD USER RSO IP=192.168.202.9
See Also
DELETE USER RSO
DISABLE USER RSO
ENABLE USER RSO
SHOW USER RSO
CLEAR FLASH TOTALLY
Syntax
CLEAR FLASH TOTALLY
Description
This command completely clears the FLASH memory to an erased state.
Clearing the FLASH memory is not required for normal operation. This
command intended as a troubleshooting tool to allow the FLASH file system to
be returned to a known state.
This command will destroy all existing files and reformat the FLASH memory.
Files cannot be salvaged after the FLASH memory has been erased.
While the erasure is under way the SHOW FLASH command on page 1-108
will indicate that the FFS global operation is in the “erasing” state. When the
erasure is complete a message is displayed and the global operation returns to
“none”.
The operation of erasing FLASH may take up to a minute to complete.
See Also
SHOW FLASH
CREATE CONFIG
Syntax
CREATE CONFIG=filename
where:
■
filename is a file name of the form
device:filename.ext
. Valid characters
are the lowercase letters (a–z), digits (0–9) and the hyphen character (-).
Wildcards are not allowed.
Description
This command creates a script file containing the commands required to
recreate the current dynamic configuration of the router.