System information

Operation ADD USER 1-47
Software Release 2.0.1
C613-03018-00 REV A
■ ipadd is an IP address in dotted decimal notation.
■ network is a valid Novell network number, expressed as a hexadecimal
number. Leading zeros may be omitted.
Description
This command adds a user to the User Authentication Database. The USER
parameter specifies the login name for the user. It is case insensitive.
The PASSWORD parameter specifies the password for the user. The password
is case sensitive. It is intended that the PASSWORD parameter be used to set an
initial password for the user and that the user will change it to some string
known only to the user, using the SET PASSWORD command on page 1-89. A
password set with the SET PASSWORD command may contain any printing
character. A configurable minimum password length is enforced. The default is
6 characters.
The CALLINGNUMBER parameter specifies the calling number to be used to
authenticate incoming calls from L2TP and ISDN services that provide caller
ID information. While any printable characters will be accepted for this
parameter, the calling number it is to match is likely to contain only decimal
digits. Any other characters used in this parameter are unlikely to match the
calling number of an incoming call.
The CBNUMBER parameter specifies the ISDN phone number to use when
making a call back to a remote user using the PPP callback facility.
The DESCRIPTION parameter specifies a descriptive text for the entry, such as
the full name and location of the user. This string may contain any printing
character and the case is preserved in output.
The PRIVILEGE parameter specifies the privilege level for the user. The default
is USER. A user with USER privilege has access to only a limited subset of
commands, generally commands that only affect the user’s own session or
asynchronous port. A user with MANAGER privilege has access to the
complete router command set when the router is operating in normal mode, or
a subset of commands when the router is operating in security mode. A user
with SECURITY OFFICER privilege has access to the full set of commands, and
in particular, can access security commands while the router is operating in
security mode.
The TELNET parameter specifies whether or not the user is permitted to use
the TELNET command on page 11-24 of Chapter 11, Terminal Server to Telnet to
another host, or the CONNECT command on page 11-13 of Chapter 11, Terminal
Server to access a Telnet service when logged in via Telnet.
The IPADDRESS parameter specifies an IP address for the user. The value must
be a valid IP address in dotted decimal form.
The IPXNETWORK parameter specifies the Novell network number assigned
to the user accessing a Novell internetwork. See Chapter 18, Asynchronous Call
Control for more information. The network number may be cleared by setting
IPXNETWORK to NONE instead of a network number. The default is NONE.
The NETMASK parameter specifies an IP network mask for the user. The value
must be a valid IP address in dotted decimal form.
The MTU parameter specifies a Maximum Transmission Unit value for the
user. The value must be a decimal integer in the range 40 to 1500 inclusive.