System information

1-130 SHOW USER AR Series Router Reference Manual
Software Release 2.0.1
C613-03018-00 REV A
Figure 1-41: Example output from the SHOW USER CONFIGURATION command.
Logins The number of times a successful login has been made
using this login name.
Fails The number of times an incorrect password was given for
this login name.
Sent The number of octets sent by the user to the router.
Rcvd The number of octets set to the user from the router.
Active (logged in) Users
This section summarises the users currently logged in.
user The login name of the user.
Port/Device The port or device on the router that the user is logged in
to; one of ‘Port x’, Telnet x’ or ‘SSH x’, where x is the device
instance.
Location The location of the user, either ‘local’ if the user is attached
to an asynchronous port or the IP address of the remote
device.
Login Time The time the user most recently logged in.
Table 1-35: Parameters displayed in the output of the SHOW USER command.
Parameter Meaning
User Authentication Facility configuration and counters
--------------------------------------------------------------------------------
Security parameters
login failures before lockout ............ 4 (LOGINFAIL)
lockout period ........................... 20 seconds (LOCKOUTPD)
manager password failures before logoff .. 3 (MANPWDFAIL)
maximum security command interval ........ 30 seconds (SECUREDELAY)
minimum password length .................. 6 characters (MINPWDLEN)
TACACS retries ........................... 3 (TACRETRIES)
TACACS timeout period .................... 5 seconds (TACTIMEOUT)
semi-permanent manager port .............. 0
Security counters
logins 7 databaseClearTotallys 0
managerPwdChanges 0 defaultAcctRecoveries 0
unknownLoginNames 1 tacacsLoginReqs 1
totalPwdFails 5 tacacsLoginRejs 1
managerPwdFails 3 tacacsReqTimeouts 0
securityCmdLogoffs 1 tacacsReqFails 0
loginLockouts 1
--------------------------------------------------------------------------------
Table 1-36: Parameters displayed in the output of the SHOW USER
CONFIGURATION command.
Parameter Meaning
login failures before lockout The default number of login failures allowed by a user
before the login prompt is withheld for the lockout
period.
lockout period The default lockout period, in seconds, that the login
prompt will be withheld from a user after a number of
consecutive login failures.