System information

1-118 SHOW MANAGER PORT AR Series Router Reference Manual
Software Release 2.0.1
C613-03018-00 REV A
See Also
DELETE MAIL
DISABLE MAIL DEBUG
ENABLE MAIL DEBUG
MAIL
SHOW MAIL
SHOW MANAGER PORT
Syntax
SHOW MANAGER PORT
Description
This command displays the port number of the current semipermanent
manager port, if any. There may be no more than one semipermanent manager
port at any time. If a semipermanent manager port is defined, a message like:
The manager port is port 0
is displayed. If no semipermanent manager port is defined, the message:
No manager port is defined.
is displayed.
See Also
LOGIN
SET MANAGER PORT
SET PORT in Chapter 2, Interfaces
SHOW NVS
Syntax
SHOW NVS [BLOCK=id [INDEX=index]]
where:
■
id is a block ID number in hexadecimal.
■
index is a block index number in hexadecimal.
Description
This command shows the contents of the nonvolatile storage (NVS). If the
BLOCK parameter is specified then only blocks with the specified id are
shown. If the INDEX parameter is specified then only the block with the
specified id and index are shown (Figure 1-31 on page 1-119, Table 1-29 on
page 1-119).
For security reasons this command will only be accepted if the user has SECURITY
OFFICER privilege.