System information

1-116 SHOW MAIL AR Series Router Reference Manual
Software Release 2.0.1
C613-03018-00 REV A
See Also
LOAD
SET LOADER
UPLOAD
SHOW MAIL
Syntax
SHOW MAIL
Description
This command displays the current configuration of the email system, and any
email messages that are currently queued for transmission.
Table 1-27: Parameters displayed in the output of the SHOW LOADER command.
Parameter Meaning
Defaults This section lists the default values used for parameters not
specified in the LOAD and UPLOAD commands.
Current Load This section lists the values currently being used to load a file to
or from the router.
Last Load This section lists the values last used to load a file to or from the
router.
Method The method used to load files; one of “TFTP”, “HTTP”, “WEB”,
“WWW”, “ZMODEM” or “NONE”.
File The name of the file to be loaded.
Server The IP address or host name of the server. Used only when
METHOD is set to TFTP or HTTP.
HTTP Proxy The IP address or host name of the proxy server when METHOD
is set to HTTP and access is via a proxy server.
Proxy Port
TCP Port
The port on the proxy server when METHOD is set to HTTP and
access is via a proxy server.
Port The asynchronous port on the router when METHOD is set to
ZMODEM or NONE.
Destination The destination for the file loaded; one of “FLASH” or “NVS”.
Delay The delay, in seconds, to wait before starting to load a file.
Status The status of the LOADER module; one of “Idle”, “Waiting”,
“Loading”, “Load Complete” or “Load Aborted”. If the SHOW
LOADER command shows a Status of “Load Complete” or
“Load Aborted”, the next SHOW LOADER command will show
a Status of “Idle” (unless another LOAD is initiated first).
Load Level The progress of the load as a percentage of the file downloaded.
This is only displayed if the LOADER Status is “Loading”.
Last Message The last error or informational message sent to the device from
which the last LOAD command on page 1-70 was issued. At
router boot, the Last Message is undefined and shows as “-”.
This is not displayed if the LOADER status is “Loading’.