Installation guide

Network Adapter Card Installation Guide - Book II

❑ CLPSS (Check Local Port and Segmentation Status): This mode

supports the same functions as the CLP mode, and additionally

checks network segmentation by sending BPDU hello packets.

Thus, this mode is only to be used if Gigabit Ethernet switches are

installed on the network that have been configured to use the

Spanning Tree protocol.

❑ DualNet: In this mode, the two ports on one adapter are treated as

separate interfaces, with different IP addresses and independent

operation. Please refer to section 5 for details.

Note

RLMT modes "CLP" and "CLPSS" are designed to operate in

configurations where a network path between the ports on one

adapter exists. Moreover, they are not designed to work where

adapters are connected back-to-back or for adapters operated in

Dual Net mode.

Note

If the adapter is configured for the use of VLANs, make sure that

both switch ports belong to the same VLAN as both adapter ports.

RlmtChgBCPrio_InstX

Type: string

Default value: No

Valid values: Yes

This parameter specifies whether received broadcast packets have the

highest priority for the port switch decision (No) or not (Yes).

JumboFrames_InstX

Type: string

Default value: OFF

Valid values: ON

OFF

Note

This parameter is valid in Single Net mode only. For Dual Net mode

please refer to Per-port Parameters on page 76.