Installation guide

AT-2971 Solaris Sparc
80
Per-adapter
Parameters
In the following description, 'X' stands for the instance number of the
according adapter.
PreferredPort_InstX
Type: string
Default value: A
Valid values: A
B
Note
This parameter is only available for dual link adapters.
This parameter determines the preferred port RLMT (Redundant Link
Management Technology) will use for all network traffic, if more than
one port has an active link to the network.
RlmtMode_InstX
Type: string
Default value: CLS
Valid values: CLS
CLP
CLPSS
DualNet
Note
This parameter is only available for dual link adapters.
Use this parameter to set the operational mode for the Redundant Link
Management Technology (RLMT, the driver function that decides which
port to use):
❑ CLS (Check Link State): RLMT uses the link state reported by the
adapter hardware for each individual port to determine whether
a port can be used for all network traffic or not.
❑ CLP (Check Local Port): In this mode, RLMT monitors the network
path between the two ports of an adapter by regularly
exchanging packets between them. Please configure your
network in a way that the link between the ports sends LLC test
packets. This mode requires a network configuration in which the
two ports "see" each other (i.e. no router between the ports).