Installation guide

Network Adapter Card Installation Guide - Book II

Note

Sense-mode will fail if your link partner is configured to half-duplex

with no auto-negotiation enabled. AutoNegotiation_? and

DuplexCapabilities_? have to be set manually in this case.

Note

Sense-mode is not possible with 1000Base-T (copper) adapters. If

you select Sense, it will be mapped to ON automatically.

DuplexCapabilities_?_InstX

Type: string

Default value: Both

Valid values: Half

Full

Both

Both: Port can connect with full-duplex and half-duplex.

Full: Port connects with full-duplex.

Half: Port connects with half-duplex.

This parameter is ignored if 'AutoNegotiation' is set to Sense.

If auto-negotiation is set to ON, all three values are possible. If it is set to

OFF, only Full or Half are allowed. This parameter is useful if your link

partner does not support all possible combinations.

FlowControl_?_InstX

Type: string

Default value: SymOrRem

Valid values: Sym

SymOrRem

LocSend

None

This parameter can be used to set the flow control capabilities the port

reports during auto-negotiation.