Installation guide

Novell Netware
50
Installing a Network Adapter Driver on Novell Netware 4
Server
This section contains the procedure for installing a network adapter
driver on a system running Novell NetWare 4 Server.
Files Needed for
Installation
The .LDI file and the .LAN file for your adapter must be present to
succesfully complete installation. The location for each Allied Telesyn
adapter are as follows:
New Server
Installation
1. Follow the directions provided by Novell to load the network drivers
using the INSTALL.NLM program.
2. When the Install program prompts for the LAN driver, select Insert
to specify a driver not listed.
3. Insert the CardAssistant CD or driver installation disk into the
appropriate drive.
4. Press <F3> to change the default path to A:\NETWARE. Press
<Enter> as prompted. The adapter driver and other required files
will be copied to the SYS: volume.
5. On the next menu, AT-2xxx Protocols and Parameters, specify any
parameters where needed. A slot value is required when loading the
adapter driver. If slot is unknown, driver will correctly detect slot
value when loading.
6. Select Save parameters and load driver. The Netware 4.x driver has a
PermaNet parameter that gives the Netware Server a redundancy
mechanism where two network adapters are connected to the same
Adapter Card Location
AT-2400 Series \drivers\at2400\netware\
AT-2500/AT-2501 Series \drivers\at2500\netware\
AT-2450/AT-2451 Series,
AT-2700/AT-2701 Series,
AT-2746 Series
\drivers\at24_27\netware\
AT-2915 Series, AT-2930
Series
\drivers\at29xx\netware\
AT-2916T, AT-2970,
AT-2971 Series
\drivers\at2971\netware\
1
1. For additional AT-2916T, AT-2970, and AT-2971 parameter information, refer to the
AT297x.txt file.