Installation guide

Network Adapter Card Installation Guide - Book II
45
Note
These are the default values for installation. If you are adding any
TCP/IP software, this configuration will satisfy the NDIS 2.0
requirements of TCP/IP systems.
NetWareIPXODI
Support for
NetWare 3.x
1. Create a new directory on your local hard drive (e.g.; C:\ATINET).
2. Copy the contents of the DOSODI directory on the CardAssistant CD
or the Driver Installation Disk to the directory you created.
If you are using the CardAssistant CD, the location of the
appropriate driver will differ depending on the type of adapter.
Below are the driver locations on the CardAssistant CD:
If you are using a driver installation diskette, the driver location is
\Dosodi.
3. Verify that the ODI drivers for the AT-2500/AT-2501 Ethernet
Adapter Card are NOT loaded before setting up Windows for
Workgroups.
4. Start Windows.
5. Choose Network Setup from the Network group.
6. Select Networks.
7. Select Install Microsoft Windows Network, then Other.
8. Select Novell NetWare (Workstation Shell 3.X), then OK.
9. Select IPXODI.COM and LSL.COM (recommended), then OK.
10. Verify that ATI AT-xxxx[ODI/NDIS2] and its default protocols,
Microsoft NetBEUI and IPX/SPX Compatible Transport with
NetBIOS, appear in the Network Drivers list, then OK.
11. When asked if you want to modify the net.cfg file, you can enter the
path to the directory created earlier for your ODI files (for example,
C:\ATINET). After you make your changes, or if you do not want to
make changes, click OK.
Adapter Card Location
AT-2400 Series \drivers\at2400\Dosodi
AT-2500/AT-2501 Series \drivers\at2500\Dosodi
AT-2450 Series, AT-2700
Series
\drivers\at24_27\Dosodi