Installation guide

Diagnostics
32
The Main Menu as shown in Figure 8 is displayed:
Figure 8 Diagnostic Window (3 of 5)
6. Select the appropriate item from the menu.
7. To quit the program, select EXIT in the Main Menu.
This option is automatically offered for selection if you did not select
a menu item previously.
Reading Sensor
Data
To read sensor data, perform the following procedure:
1. Start the main program. Refer to Main Program
on page 31 for
instructions.
2. Select Show Sensors in the Main Menu. A separate window will be
displayed for the following sensor data:
❑ Temperature of the board
❑ Voltage on the PCI card
❑ Voltage on the PCI I/O lines
❑ Other supply voltages
In the Main Menu, Show Sensors changes to Hide Sensors.