Installation guide

Diagnostics
22
Running Diagnostics
For the AT-24xx
Series
Command line option for diag.exe:
-d Run command-line diagnostics
-e Enable External Loopback Test when running diagostics
-pme Enable PME OverWrite mode
-nopxe Disable boot ROM support
-pxe Enable boot ROM support
-0 Auto-negotiation
-1 100Mb/half-duplex
-2 100Mb/full-duplex
-3 10Mb/half-duplex
-4 10Mb/full-duplex
-5 Enable copper port as default
-6 Enable fiber port as default
For the
AT-24xx,
AT-25xx,
AT-27xx,
AT-2915, and
AT-2930 Series
The diagnostics utulity is useful for setting the Speed/Duplex and
BootROM. You can also insure proper operation of the network adapter
card. This utility is located on the CardAssistant CD or the driver
installation disk.
Speed/Duplex
This option allows the user to configure speed and duplex to one of the
available options. The options for speed and duplex vary depending on
adapter model
BootROM Port
The BootROM port setting is only for multi-port AT-2450, AT-2700, and
AT-2745 Series PCI Ethernet Adapter Cards without integrated Manage
BootROM, specifically the AT-2450FTX, AT-2700FTX, and AT-2745FX.
When using one of these three adapters in a BootROM configuration, it
may be necessary to change these settings. For any other AT-2450 or
AT-2700 Series PCI Ethernet Adapter Card the BootROM Port setting
should not be changed.
BootROM
This feature is only available for the AT-2500 and AT-2501TX Series
Adapters. Using the Diagnostics program (diag25.exe) set BootROM to
enable.