Installation guide

Network Adapter Card Installation Guide - Book II
119
The AT-2500 and AT-2501 adapter cards will require the card to be
configured for Boot ROM support, it is disabled by default. To enable
Boot ROM support, start the AT-2500 or AT-2501 DOS diagnostics
program, setup25 and enable the Boot ROM from the configuration
menu.
BootROM
Parameter
1. Run the diagnostics program that came with your Allied Telesyn
adapter. (diag.exe, diag25.exe, etc.).
2. If using an AT-2450 and AT-2700 series Combo card, set the
BootROM Parameter to the desired port (copper or fiber). If using an
AT-2500 series adapter set the BootROM parameter to enable.
For the AT-2450FTX, AT-2700FTX, and AT-2745FX versions with switches
you must set your switch to the proper position based on which port you
are using (Copper or Fiber).
Note
For proper operation when BootROM is NOT installed insure the
Diagnostics parameter BootRom and switch are set to Factory
Default.
Table 1 AT-2450FTX
Diag Setting Switch Position
Copper
1
1. Factory default.
Up
1
Fiber Down
Table 2 AT-2700FTX
Diag Setting Switch Position
Fiber
1
1. Factory default.
Down
1
Copper Up
Table 3 AT-2745FX
Diag Setting Switch Position
100 Mb
1
1. Factory default.
Up
1
10 Mb Down