Installation guide

Network Adapter Card Installation Guide - Book II
113
Error Messages
This section describes error messages that may be printed by the driver.
This list is incomplete! If you get other error messages and you can not
solve the problem, contact Allied Telesyn technical support.
Note
In all following error messages, <InstanceNumber> is a placeholder
for the instance number assigned to the adapter by the system.
Message Meaning
"skge<InstanceNumber>: Getconfiguration:
Missing VLAN parameter <ParameterName>!"
<ParameterName> can be any name
described as 'MUST be set' in Dual Net
Operation Mode on page 86.
You have configured the adapter
skge<InstanceNumber> for the use of
VLANs and forgotten to set a parameter
that is essential for the correct
functionality of a VLAN (Virtual LAN)
device. If so, the attachment of the
adapter is aborted.
"skge<InstanceNumber>: Getconfiguration: Illegal
value for <ParameterName>, using default!"
<ParameterName> can be any parameter
name described in Driver Parameters on
page 75. You have entered an invalid
value for this parameter in the driver
configuration file.
"skge<InstanceNumber>: SkGeAttach:
ddi_soft_state_zalloc failed!"
Not enough kernel memory is available
for the driver.
"skge<InstanceNumber>: Adapter failed." A serious driver or hardware problem has
occurred. This will prevent the adapter
from working correctly.
"skge<InstanceNumber>: Port <A|B> failed." Same as the previous message, but for
the port only.
"skge<InstanceNumber>: BoardAllocMem:
ddi_dma_mem_alloc failed!"
The driver could not get enough DMA
memory. See the section above for a
solution.