Installation guide

AT-2971 Solaris Sparc
108
- Duplex Mode: half- or full-duplex mode?
- Flow Control: used mode
- Role: this parameter is only valid with
1000Base-T
adapters (SK-9821, SK-9822 and SK-9821 V2.0). Please refer to
parameter Role_?_InstX in Per-port Parameters on page 76 for
details.
- dual_net : Dual Net mode enabled?
- vlan_props : if VLAN support is enabled on the according interface, a
list of four parameters (used in skge.conf) is displayed:
- VLAN Number: used for configuration purposes
- VLAN ID: set by user
- VLAN Port: port used by this VLAN
- VLAN Jumbo Frames: jumbo frames enabled?
If VLAN support is disabled, the following message is displayed:
"No VLAN support on skgeX enabled."
X is the number of the corresponding interface.
- vct_start : Start a VCT cable test on the selected interface.
- vct_status : Get the actual VCT/DSP status of the selected interface.
- vct_result : Get the result of the last VCT/DSP cable test of the selected
interface.
Refer to Error Messages on page 113 for details about the VCT
parameters.
Example: If you want to know the adapter identification string of the
adapter belonging to IP interface skge0, enter the command:
ndd /dev/skge0 adapter_id