User guide

Software Engineering Interface Association
Telesyn Service Guide (Optimizing Data Services (SHDSL))
2-6
2.5 Software Engineering
2.5.1 Interface Association
In bonded mode, each bonded port (consisting of 2 physical pairs, represented by the even numbered port) has
the following associated interfaces:
• Two SHDSL interfaces, one for each physical pair
• One ATM interface is multiplexed over the two “bonded” ports
• At least one AAL5 Virtual Channel interface for the bonded port
• At least one ETH interface for the bonded port
FIGURE 2-4 SHDSL Interface Association
All attributes are applied to both wire pairs of the bonded port and the maximum connect rate and minimum con-
nect rate range is increased to 4624 (2312 x 2).
Note: Bonded interfaces only connect at the MaxConnectRate; the MinConnectRate parameter may
be ignored.
In bonded mode, each physical wire pair can have differing runtime attributes, depending on external conditions
of each physical wire pair.
2.5.2 Conversion from Normal to Bonded SHDSL
Note: This does not apply to Release 5.0.
5.0.0 5.0.1 5.0.2
5.0.0 5.0.1 5.0.2
5.0.1 5.0.2
5.0
ETH
AAL5
ATM
SHDSL